LSL Klemmbock-Kit MT-09, schwarz, Lenkererhöhung
€139.95
The product is currently unavailable, but we will be happy to notify you by e-mail
We’ll remind you
Please enter your email address so that we can notify you as soon as the item is available again in your desired size.
Description
X-Bar Clamps (KM45) for 28.6 mm handlebars suitable for following vehicle:
Yamaha
MT09
Material: Aluminum
Material Treatment: anodized
Offset: + 25 mm
or
Offset: + 5 mm
Dimensions: 28.6 mm Clamps
Our model-specific X-Bar Clamps are mounted at the original mounting points. So many models with original 22.2mm handlebars can mount an X-Bar handlebar.
After the modification it is now also possible to operate the ignition lock with the right hand. In standard condition, the key can only be inserted with the left hand.
On models with standard rubber bearings, this is retained. Depending on the model, the handlebar position changes from -50mm to +30mm, the value for your motorcycle is indicated under offset.
NEWNOTE IMPORTANT NOTE: Please check before the conversion whether the vehicle intended for the conversion is listed in the attached ABE!
For each vehicle there are different conditions and requirements that allow a conversion of the clamp blocks.
The model assignments of the LSL terminal blocks listed in the ABE are tested for use with the vehicle's standard handlebar.
The additional use of an LSL accessory handlebar is possible, but may require additional modifications to the vehicle (longer cables or cables) due to a different shape of the handlebar.
The increase in the original handlebar can also lead to additional modifications to the vehicle.
Check whether the following conditions apply to your vehicle (-see ABE):
- Use permitted when using a fork bridge compensation pad
- With 20 mm longer brake line Use permitted
- With 30 mm longer brake line Use permitted
- With LSL instrument holder Use permitted
Failure to observe these instructions will void the vehicle's operating permit!
The following items are suitable for this product: 28.6 mm handlebars X-Bar
Yamaha
MT09
Material: Aluminum
Material Treatment: anodized
Offset: + 25 mm
or
Offset: + 5 mm
Dimensions: 28.6 mm Clamps
Our model-specific X-Bar Clamps are mounted at the original mounting points. So many models with original 22.2mm handlebars can mount an X-Bar handlebar.
After the modification it is now also possible to operate the ignition lock with the right hand. In standard condition, the key can only be inserted with the left hand.
On models with standard rubber bearings, this is retained. Depending on the model, the handlebar position changes from -50mm to +30mm, the value for your motorcycle is indicated under offset.
NEWNOTE IMPORTANT NOTE: Please check before the conversion whether the vehicle intended for the conversion is listed in the attached ABE!
For each vehicle there are different conditions and requirements that allow a conversion of the clamp blocks.
The model assignments of the LSL terminal blocks listed in the ABE are tested for use with the vehicle's standard handlebar.
The additional use of an LSL accessory handlebar is possible, but may require additional modifications to the vehicle (longer cables or cables) due to a different shape of the handlebar.
The increase in the original handlebar can also lead to additional modifications to the vehicle.
Check whether the following conditions apply to your vehicle (-see ABE):
- Use permitted when using a fork bridge compensation pad
- With 20 mm longer brake line Use permitted
- With 30 mm longer brake line Use permitted
- With LSL instrument holder Use permitted
Failure to observe these instructions will void the vehicle's operating permit!
The following items are suitable for this product: 28.6 mm handlebars X-Bar
