Kellermann flasher relay R1, 6 and 12 Volt
34,95 €
Spomnili vas bomo
Vnesite svoj e-naslov, da vas bomo lahko obvestili, ko bo izdelek ponovno na voljo v želeni velikosti.
Opis
Microrelais für Profis
Made in Germany
ECE-tested
Simple installation in supply line to flasher switch
Connection option for flasher indicator light
Prevents flashing of non-actuated flashers
Load-independent / quiet flashing sequence (75/min)
Switching capacity 0,5 - 50 Watt
Very small dimensions 21 x 11 x 6 [mm] (L/B/H)
Suitable for turn signal switches
Suitable for 6 and 12 Volt on-board electrical systems
Price per piece
The R 1 flasher relay has very small dimensions, always flashes at a steady 75 flashing pulses per minute regardless of the load and has a connection option for the flasher indicator light. It is simply installed in the line leading to the turn signal switch or replaced with the original turn signal relay. It is therefore suitable for all motorcycles with indicator switch. If, after conversion to LED indicators, the indicators that have not been actuated flash unintentionally, the indicator control lamp must be connected to the R 1. In this way, the warning flashing effect is reliably eliminated. All necessary components for installation are included in the scope of delivery.
Made in Germany
ECE-tested
Simple installation in supply line to flasher switch
Connection option for flasher indicator light
Prevents flashing of non-actuated flashers
Load-independent / quiet flashing sequence (75/min)
Switching capacity 0,5 - 50 Watt
Very small dimensions 21 x 11 x 6 [mm] (L/B/H)
Suitable for turn signal switches
Suitable for 6 and 12 Volt on-board electrical systems
Price per piece
The R 1 flasher relay has very small dimensions, always flashes at a steady 75 flashing pulses per minute regardless of the load and has a connection option for the flasher indicator light. It is simply installed in the line leading to the turn signal switch or replaced with the original turn signal relay. It is therefore suitable for all motorcycles with indicator switch. If, after conversion to LED indicators, the indicators that have not been actuated flash unintentionally, the indicator control lamp must be connected to the R 1. In this way, the warning flashing effect is reliably eliminated. All necessary components for installation are included in the scope of delivery.
