HIGHSIDER AKRON-RS PRO for Yamaha MT-10 22-

HIGHSIDER AKRON-RS PRO license plate holder incl. license plate light

The design of the HIGHSIDER AKRON-RS PRO license plate holder perfectly matches the lines of your bike.

The model-specific bracket of the AKRON-RS PRO allows it to be mounted on the original mounting points of your bike and thus replaced without the need for drilling or cutting.
To prevent damage to cables, all sharp-edged feed-throughs are protected by a rubber membrane grommet.

The license plate is made of sheet steel and is 2 mm thick. The precise cutting is done by laser. After edging, a weather-resistant black powder coating is applied.
This ensures an optimum fit and durability.
The infinitely variable adjustment option allows you to move the panel to the desired position without drilling. There is an additional locking screw to hold the plate in this position.

The width of the AKRON-RS PRO blinker brackets can be adjusted, making them suitable for all types of accessory indicators. This adjustment option allows you to adapt the position of your indicators to a wide variety of license plates. To enable the indicators to be fitted without disconnecting them from the wiring harness, the 10 mm holes are slotted to the side.

You can also adjust the position of the rear reflector individually using a slider. Adaptation to the different versions of EU license plates is therefore no problem.

Two rubber washers are included to securely screw the license plate and reduce vibrations. Another rubber buffer supports the license plate on its underside.

This PRO version of the AKRON-RS includes the very small HIGHSIDER license plate light milled from high-quality aluminium with mounting plate and support arm. The bracket is height-adjustable and designed so that it can be mounted in the legally prescribed position.e.g. drilling)
- easy mounting of the license plate thanks to slotted holes
- license plate light incl. holder included
. bracket included
- license plate light, E-approved
- infinitely adjustable license plate light
- many different options for attaching the license plate light


The scope of delivery of the AKRON-RS PRO includes:
- Model-specific bracket with mounting parts
- AKRON-RS license plate mounting plate
- Adjustable blinker brackets
- E-approved reflector with adjustable bracket
- E-approved license plate light
- Installation instructions


Notes:
- A special blinker bracket is optionally available for the original indicators in the Accessories tab.
- If side reflectors are fitted to your original license plate holder, these must be refitted in a suitable position or replaced with new ones.

Tip:
If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different designs, are certainly a good alternative.

Οδηγίες τοποθέτησης:

Λήψη