384,37 kr
SJEKK TILGJENGELIGHET I BUTIKKEN
Tilgjengelighet i butikken
Hent produktet i dag
Reserveres eksklusivt for deg i to dager
God tid til å teste før du kjøper
Bestill produktet på nett, og hent det i butikken.
FC-Moto Store
Aachener Str. 21-23
52146 Würselen
Åpningstider
Man. til fre. kl. 10–19
Lørdag kl. 10–18
Vi sender deg en påminnelse
Skriv inn e-postadressen din, slik at vi kan varsle deg så snart varen er tilgjengelig igjen i ønsket størrelse.
Beskrivelse
The sealed inline battery to motorcycle USB-C charger (5V 3300mA) with a length of 150cm and a 50cm battery connection cable with M6 eyelet connector, allows safe and fast USB charging of any device mounted on the outside of the handlebar, tank or hard case - The cable is routed to where the USB charging is needed!
- Ideal for 12V AGM & 12.8V LiFeP04 / LFP lithium batteries in your motorcycle
- Charges cell phone, GPS, camera or tablet
- Charges 1x USB device with up to 5V 3300 mA
- The charging current adjusts to the connected device for safe charging
- Supply cable 50 cm with M6 eyelets, suitable for all motorsport battery terminals
- Protected with fuse!
- Can be used for normal temperatures and outdoor use up to -20 degrees
- Incl. USB-C cable
Protection function:
The built-in protection shuts off USB charging when the vehicle battery voltage < 12.4V and thus prevents the LFP or AGM battery of your parked vehicle from being discharged.
Specification:
Fully automatic operation
- Protection of the vehicle battery: automatic shutdown at an input voltage <12.4V, protects the vehicle battery from total discharge. Voltage range: 12.4 to 16Vdc.
- Turns on when the voltage of the vehicle battery above 13.3V rising
- 2 LED battery monitor
- Protection against short circuit, overheating and overvoltage. The battery connection cable contains an inline fuse.
Operating states:
- USB charging in the voltage range of 13.3V to 18V: Unlimited USB output, USB LED on. Provides USB power when the vehicle engine is charging the battery.
- USB 1 hour in the voltage range of 12.4V to 13.3V: 1 hour USB output, USB LED on. Changes after 1 hour or voltage < 12.4V to standby mode.
- Standby mode: voltage monitoring, turns on again when the voltage of the vehicle battery above 13.3V increases.
- AGM/LFP monitor: LED flashes every 5 seconds when battery charge is ≥ 50%, sufficient to start the vehicle engine.
- LED LFP: 13.1V to 13.3V.
- LLED AGM: 12.4V to 13.1V.
- NO LED: < 12.4V.
- OFF ≤ 9V
Cable classification: SPT-1
Use range: -20°C/-4°F very low temperature, remains flexible in sub-freezing temperatures
Design: fully encapsulated electronic circuits with multiple LEDs, unique seal and cap design for USB socket, use any USB cable, sealed when plugged in.
Scope of delivery:
- USB-C charger
- Battery connection cable
- USB-C cable.
- Ideal for 12V AGM & 12.8V LiFeP04 / LFP lithium batteries in your motorcycle
- Charges cell phone, GPS, camera or tablet
- Charges 1x USB device with up to 5V 3300 mA
- The charging current adjusts to the connected device for safe charging
- Supply cable 50 cm with M6 eyelets, suitable for all motorsport battery terminals
- Protected with fuse!
- Can be used for normal temperatures and outdoor use up to -20 degrees
- Incl. USB-C cable
Protection function:
The built-in protection shuts off USB charging when the vehicle battery voltage < 12.4V and thus prevents the LFP or AGM battery of your parked vehicle from being discharged.
Specification:
Fully automatic operation
- Protection of the vehicle battery: automatic shutdown at an input voltage <12.4V, protects the vehicle battery from total discharge. Voltage range: 12.4 to 16Vdc.
- Turns on when the voltage of the vehicle battery above 13.3V rising
- 2 LED battery monitor
- Protection against short circuit, overheating and overvoltage. The battery connection cable contains an inline fuse.
Operating states:
- USB charging in the voltage range of 13.3V to 18V: Unlimited USB output, USB LED on. Provides USB power when the vehicle engine is charging the battery.
- USB 1 hour in the voltage range of 12.4V to 13.3V: 1 hour USB output, USB LED on. Changes after 1 hour or voltage < 12.4V to standby mode.
- Standby mode: voltage monitoring, turns on again when the voltage of the vehicle battery above 13.3V increases.
- AGM/LFP monitor: LED flashes every 5 seconds when battery charge is ≥ 50%, sufficient to start the vehicle engine.
- LED LFP: 13.1V to 13.3V.
- LLED AGM: 12.4V to 13.1V.
- NO LED: < 12.4V.
- OFF ≤ 9V
Cable classification: SPT-1
Use range: -20°C/-4°F very low temperature, remains flexible in sub-freezing temperatures
Design: fully encapsulated electronic circuits with multiple LEDs, unique seal and cap design for USB socket, use any USB cable, sealed when plugged in.
Scope of delivery:
- USB-C charger
- Battery connection cable
- USB-C cable.
| Henrettelse: | Lader |
|---|