The Eclipse jacket brings it back to basics when it comes to riding in high temperatures. The impact zones are made of abrasion resistant polyester 600D, while the front, back, and inner arms are mesh to allow full airflow to the upper body. CE-rated body armor comes standard and is upgradable with our SEESOFT™ CE-level 2 back protector. Various adjustment straps allow the rider to create a close fit, and the jeans loops allow the Eclipse to be attached to our REV'IT! jeans.

PROTECTION FEATURES

Outer shell mesh | polyester 600D
Protection Knox® Flexiform CE protection | prepared for SEESOFT™ CE-level 2 back protector insert - Type RV
Visibility laminated reflective logo
Composition 100% Polyester

ERGONOMIC FEATURES

Fit tour fit | regular
Adjustability adjustment straps | adjustment tabs
Ventilation ventilation panels
Features double jeans loop
Pockets slit pockets | inner pocket

Color:	Silver
Size:	XS
Tops Type:	Jackets
Features:	removable inner lining
Gender:	Men
Material:	Textile
Season:	Summer
Application area:	Classic / Chopper, Touring, Urban / City
Material composition:	100% Polyester

Show more Show less

Size table

Size table for Revit Eclipse Textile Jacket:

Measurements in:

inch

Size	Chest (cm)	Waist (cm)
S	90 - 96	77 - 83
M	96 - 102	83 - 89
L	102 - 108	89 - 96
XL	108 - 115	96 - 104
XXL	115 - 123	104 - 113
3XL	123 - 132	113 - 122

How to measure your height:

1 Shoulder width

Measure your shoulder width across your back from the outer edge of one shoulder to the outer edge of the other. Stand upright and let your arms hang relaxed at your sides. Guide the tape measure from shoulder point to shoulder point across the upper back and make sure it does not slip.

2 Chest circumference

Measure your chest circumference at the fullest part of your chest. Run the tape measure horizontally around your upper body under your arms. Make sure the tape stays level and breathe naturally without puffing out your chest.

3 Waist

Measure your waist at the narrowest part of your torso, usually just above your belly button. Stand upright and keep breathing normally while you place the tape measure horizontally around your body. Make sure the tape is not digging in but also not too loose, so you get a realistic measurement.

4 Hips

Measure your hips at the widest part of your buttocks. Stand upright with your feet about hip-width apart and place the tape measure horizontally around your body. Make sure the tape stays at the same height all the way around and does not slip up or down.

5 Arm length

Measure your arm length from the outer shoulder point to your wrist. Let your arm hang naturally and relaxed at your side. Run the tape measure along the outside of your arm down to the wrist.

6 Inseam

Measure your inseam from the crotch down along the inside of your leg to the sole of your foot. Stand upright, ideally without shoes and with your legs slightly apart. Run the tape measure straight down and make sure it does not slip.

7 Outseam

Measure the outside leg length from your hip down the outside of your leg to the sole of your foot. Stand upright and barefoot with your legs naturally straight. Place the tape measure at the side of your hip and run it straight down to the sole. Make sure it stays close to your body and does not slip.

8 Thigh

Measure your thigh at the fullest part. Wrap the tape loosely around your leg without pulling it tight. For an accurate result, stand relaxed and distribute your weight evenly on both legs.

Revit Eclipse Textile Jacket

Size table for Revit Eclipse Textile Jacket:

How to measure your height:

Reviews

Log in