Vehicle-specific adapter cable with integrated simulation electronics for front or rear turn signals. <i.LASH products include all parts necessary to ensure that after a turn signal conversionthe flashing frequency is correct and no error messages are displayed in the instrument panel.
The scope of delivery includes two adapter cables for the turn signals with plugs matching the vehicle, if necessaryintegrated matching electronics and if necessary a load-independent flasher relay.
- Vehicle-compatible plug connection
- Very simple connection
- Correct flashing frequency
- NoneError messages in the cockpit
- Trouble-free operation of all Kellermann LED indicators
Size table for Kellermann i.LASH H5 error correction adapter:
| EU-Size | US-Size | Foot Length (cm) |
|---|---|---|
| 38 | 5 | 24 |
| 39 | 5.5 | 24.5 |
| 39.5 | 5.5 | 24.7 |
| 40 | 6 | 24.9 |
| 41 | 7 | 25.7 |
| 42 | 8 | 26.5 |
| 43 | 9 | 27.3 |
| 44 | 9.5 | 27.7 |
| 44.5 | 10 | 28.1 |
| 45 | 10.5 | 28.5 |
| 46 | 11 | 28.9 |
| 47 | 12 | 29.7 |
| 48 | 13 | 30.6 |
| 49 | 14 | 31.4 |
How to measure your height:
Measure your foot length from the heel to the tip of your longest toe. Stand barefoot on a sheet of paper and distribute your weight evenly. Mark the very back of your heel and the tip of your longest toe, then measure the distance between those two points. Make sure you are standing straight, because the foot expands slightly under weight.
Measure your foot width at the widest part of your foot, usually across the ball of the foot. Stand barefoot on a sheet of paper, mark the outermost widest points, and measure the distance between them. Make sure your foot is flat on the floor and that the marks or tape measure are not angled.
- VFR 800 X CROSSRUNNER ABS (RC60)















