HeinzBikes ALL-INN 2.0 Kennzeichenhalter mit KNZ-Beleuchtung 3in1, CHE
$514.88
The product is currently unavailable, but we will be happy to notify you by e-mail
We’ll remind you
Please enter your email address so that we can notify you as soon as the item is available again in your desired size.
Description
HeinzBikes ALL-IN 2.0 License plate holder, E-approved (for vertical shoring)
-DÜNNER- -LEICHTER- -HELLER-
THE NEW TYPE CHARACTER HOLDER GENERATION IS THERE!
Many new features and improved high-end features make the ALL-IN 2.0 CHARACTER HOLDER a premium product.
Give the rear of your motorcycle a clean look and replace all lighting units with this innovative All-in-One license plate holder.
NEW features:
40% thinner
The improved design and workmanship of new lighting units make the license plate holder 40% thinner, i.e. it is only half as thick!
140g LIGHTER
Made from high quality aluminium it is 140 grams lighter due to the new Ultra-Light construction.
50% HELLER
With the use of the new SMD-LED technology the ALL-INN 2.0 offers more safety in road traffic.
Strapazier- and more powerful than normal LEDs they shine even brighter with the same power consumption.
They are with E-test mark and TÜV for edgewise installation.
SLIP-INN OPENING
The new SLIP-INN OPENING allows easy mounting of the license plate without screws or glueing.
The ALL-IN 2.0 LABEL HOLDER also offers a mounting area for the possible installation of additional reflectors.
The LED LIGHTING of the license plate shines even brighter and is even narrower.
The slim aluminium housing was developed and manufactured by HeinzBikes and integrates itself completely into the new design of the ALL-INN 2.0.
Scope of supply: 1 piece
Note:
Also suitable for self-illuminating license plates.
In some cases, it must be installed either with a flashing frequency generator or with a resistor if the flashing frequency is too high.
Label plate must be mounted at an angle of 90 degrees to the road!
-DÜNNER- -LEICHTER- -HELLER-
THE NEW TYPE CHARACTER HOLDER GENERATION IS THERE!
Many new features and improved high-end features make the ALL-IN 2.0 CHARACTER HOLDER a premium product.
Give the rear of your motorcycle a clean look and replace all lighting units with this innovative All-in-One license plate holder.
NEW features:
40% thinner
The improved design and workmanship of new lighting units make the license plate holder 40% thinner, i.e. it is only half as thick!
140g LIGHTER
Made from high quality aluminium it is 140 grams lighter due to the new Ultra-Light construction.
50% HELLER
With the use of the new SMD-LED technology the ALL-INN 2.0 offers more safety in road traffic.
Strapazier- and more powerful than normal LEDs they shine even brighter with the same power consumption.
They are with E-test mark and TÜV for edgewise installation.
SLIP-INN OPENING
The new SLIP-INN OPENING allows easy mounting of the license plate without screws or glueing.
The ALL-IN 2.0 LABEL HOLDER also offers a mounting area for the possible installation of additional reflectors.
The LED LIGHTING of the license plate shines even brighter and is even narrower.
The slim aluminium housing was developed and manufactured by HeinzBikes and integrates itself completely into the new design of the ALL-INN 2.0.
Scope of supply: 1 piece
Note:
Also suitable for self-illuminating license plates.
In some cases, it must be installed either with a flashing frequency generator or with a resistor if the flashing frequency is too high.
Label plate must be mounted at an angle of 90 degrees to the road!