$133.39
Please enter your email address so that we can notify you as soon as the item is available again in your desired size.
Be the holeshot racer with X-Trig holeshot kit
- Easy to install
- No need to remove one side of the fork
- The articulation of the ring is placed on the side (not at the clip part, or in front of this section). Thanks to this location, the articulation is subjected to low pressure
- The life of the product is thus extended
- The ring is equipped with a 3mm screw (torque of 2.3 Nm)
- The screw diameter has been studied for tightening torque cannot be too important, and compressing the arm fork
Size table for XTRIG X-Trig Ø54mm holeshot kit Suzuki R-Z 250/450:
| EU-Size | US-Size | Foot Length (cm) |
|---|---|---|
| 35 | 2 | 22.3 |
| 36 | 3 | 23 |
| 37 | 4 | 23.7 |
| 38 | 5 | 24.3 |
| 39 | 5.5 | 25 |
| 40 | 6.5 | 25.7 |
| 41 | 7 | 26.3 |
| 42 | 8 | 27 |
How to measure your height:
Measure your foot length from the heel to the tip of your longest toe. Stand barefoot on a sheet of paper and distribute your weight evenly. Mark the very back of your heel and the tip of your longest toe, then measure the distance between those two points. Make sure you are standing straight, because the foot expands slightly under weight.
Measure your foot width at the widest part of your foot, usually across the ball of the foot. Stand barefoot on a sheet of paper, mark the outermost widest points, and measure the distance between them. Make sure your foot is flat on the floor and that the marks or tape measure are not angled.