When mounting LED flashers, depending on the flasher relay installed, problems may occur with the flashing frequency. These resistors offer an effective remedy, as they simulate a power of approx. 21 watts at 12 V.
Power resistor available in:
6.8 Ohm 25 Watt
7.5 Ohm 25 Watt
8.2 Ohm 25 Watt
10 Ohm 25 Watt
Scope of supply: 1 pair
Note:
The resistors must always be connected in parallel.
Product features
- Packing: per Paar
- Range: Highsider smart
- Range: Highsider Smart
Size table for HIGHSIDER smart Power Resistor 25 W- 8.2 Ohm, With Cable (Pair):
| EU-Size | US-Size | Foot Length (cm) |
|---|---|---|
| 38 | 5 | 24 |
| 39 | 5.5 | 24.5 |
| 39.5 | 5.5 | 24.7 |
| 40 | 6 | 24.9 |
| 41 | 7 | 25.7 |
| 42 | 8 | 26.5 |
| 43 | 9 | 27.3 |
| 44 | 9.5 | 27.7 |
| 44.5 | 10 | 28.1 |
| 45 | 10.5 | 28.5 |
| 46 | 11 | 28.9 |
| 47 | 12 | 29.7 |
| 48 | 13 | 30.6 |
| 49 | 14 | 31.4 |
How to measure your height:
Measure your foot length from the heel to the tip of your longest toe. Stand barefoot on a sheet of paper and distribute your weight evenly. Mark the very back of your heel and the tip of your longest toe, then measure the distance between those two points. Make sure you are standing straight, because the foot expands slightly under weight.
Measure your foot width at the widest part of your foot, usually across the ball of the foot. Stand barefoot on a sheet of paper, mark the outermost widest points, and measure the distance between them. Make sure your foot is flat on the floor and that the marks or tape measure are not angled.