Contains
Dust Seals x8, Needles x7, Pins, Collars - Flanged x6, Pins, Collars - Plain x3, Pins, Collars - Plain with Shoulder x1, Pins, Collars - Special x2, Washers x2
FACTORY LINKS kits contain all elements required for a full service of your linkage (including the lower shock absorber). The needle bearings, collars, pins and oil seals are specifically manufactured in order to reach OEM quality requirements, in terms of materials, dimension tolerances, hardness and surface roughness. This brings your bike back to its former condition as defined by the manufacturers.
- 52100 High Grade Steel Pins
- Zinc Plated Steel Collars
- Nitrile Butadiene Dust Seals
- Include lower shock bearing
Size table for Factory Links Suspension Linkage Repair Kit:
| EU-Size | US-Size | Foot Length (cm) |
|---|---|---|
| 38 | 5 | 24 |
| 39 | 5.5 | 24.5 |
| 39.5 | 5.5 | 24.7 |
| 40 | 6 | 24.9 |
| 41 | 7 | 25.7 |
| 42 | 8 | 26.5 |
| 43 | 9 | 27.3 |
| 44 | 9.5 | 27.7 |
| 44.5 | 10 | 28.1 |
| 45 | 10.5 | 28.5 |
| 46 | 11 | 28.9 |
| 47 | 12 | 29.7 |
| 48 | 13 | 30.6 |
| 49 | 14 | 31.4 |
How to measure your height:
Measure your foot length from the heel to the tip of your longest toe. Stand barefoot on a sheet of paper and distribute your weight evenly. Mark the very back of your heel and the tip of your longest toe, then measure the distance between those two points. Make sure you are standing straight, because the foot expands slightly under weight.
Measure your foot width at the widest part of your foot, usually across the ball of the foot. Stand barefoot on a sheet of paper, mark the outermost widest points, and measure the distance between them. Make sure your foot is flat on the floor and that the marks or tape measure are not angled.